Find an Expert
Thermal Management, Electronic Packaging, Mechanical Engineering
Worked on experimental and numerical simulation in two-phase heat and mass transfer, high-heat-flux cooling, spray, jet, flow boiling, aerospace thermal management, heat pipes, ice accretion, HVAC, turbomachinery, computational fluid dynamics: incompressible and viscous flows with heat transfer, signal processing, computer…
Thermal Systems, HVAC&R, Energy Conversion, Management, Solar, Waste, Geothermal, Heat Recovery ACM
His interests are in the dynamic behavior of two-phase flow, and heat transfer, as well as Computer-Aided Analysis/Design (CAA/CAD) of energy systems, and in particular Heating, Ventilation, Air Conditioning, and Refrigeration HVAC&R. He has special interests are in the development…
Power Plants & Components, Performance, Design, Monitoring, Diagnostic; Cogeneration; Thermodynamics
Expert he has important industrial practice and gained valuable knowledge on power plants and their components while working and studying in Switzerland, Ireland, Italy, France, and Romania. Whilst at Alstom Power Switzerland, Expert held the following positions: system/performance calculation engineer…
Reliability and Liability of Plastic Products
He has taught polymer selection at Delft University, he has carried out polymer selection for industry and he was expert witness in a number of court cases about polymer selection.
CFD and Multi-Physics Modeling, Multidisciplinary Engineering, Vacuum Science and Technology
Expert holds two top scientific degrees: Ph.D in Physics and Mathematics and the highest (post Ph.D) degree: Doctor of Science in Physics and Mathematics. He is a senior Industrial Physicist with over 30 years experience in both industrial and academia…
Computational Fluid Dynamics
Expert has extensively worked on computational fluid dynamics (CFD) simulations. He has developed new products that enable effective flow control and filtering based on CFD modeling, improving performance up to twice the efficiency compared to previous designs. He has conducted…
Advanced Heat Exchangers and R744 Air Conditioning
He designed various automotive heat exchangers (Condenser, Gas-cooler, Evaporator, Radiator, Transmission oil cooler, Coax tube heat exchanger, Glycol-refrigerant heater, PTC heater, Secondary gas-cooler, 3Fluid heat exchanger, etc). He introduced diverse inventions and improvements in the area of automotive heat exchanger…
Automobile, Design Eng, AutoCAD Inventor, Pro E, Noise & Vibration, Matlab, Heat Transfer, PLM
Expert has done basic and advance course on applied mathematics with very good grades in his engineering. He implemented his applied mathematics knowledge in engineering & educational purpose. Due to the necessity of applied mathematics's good knowledge for mechanical engineering…
Active Applications of Solar Thermal Energy: Thermophysics, Flat Plate Collector, Solar Water Heat
For 40 years he has been working in alternative energy systems. He created the design for the photovoltaic power system of the Mariner spacecraft that went to Venus and Mercury, with tilting panels to avoid overheating close to the sun.…
Thermal Analysis, Finite Element, SINDA
All models start from simple schematic models. The simple model has as few nodes as possible in order to capture important features and gain insight. Complexity is added to the models until the desired refinement and accuracy is obtained. The…